Shelly Qubino Wave PM Mini

Short description

The device is a small-format smart electricity meter that allows you to remotely monitor the electricity consumption of electrical appliances with a load of up to 16 A.

Security features

Overheating protection

• turns off its relay

• sends a notification report to the gateway (overheating detected)

• wired lights react as above (check the flashing mode when overheating is detected)

Each of the following actions clears this alarm: power cycle, short press of the S button, pressing any switch button connected to any SW (SW, SW1, SW2, …) terminal.

NOTE: Overheat protection is always active and cannot be disabled.
Additional description above in the Overheat Detection Notification section .

Overcurrent protection

The device has internal overcurrent protection. If the current exceeds 16 A + 10% (maximum switching current +10%) for more than 5 s, the device:

• turns off its relay

• sends a notification report to the gateway (overvoltage detected)

• the LED lights respond as above (check the LED flashing pattern when overcurrent is detected)

Each of the following actions clears this alarm: power cycle, short press of the S button, pressing any switch/button connected to any SW (SW, SW1, SW2, …) terminal.

NOTE: Surge protection is always active and cannot be disabled.
Additional description above in section Notification of detected overvoltage .

Surge protection

The device has internal overvoltage protection. It is valid for a standard 230 V AC supply voltage. If the voltage exceeds 240 V AC + 15% (278 V AC) for more than 5 s, the device:

• will turn off its relay

• sends a notification report to the gateway (overvoltage detected)

• the LED lights respond as above (check the LED flashing pattern when an overvoltage is detected)

Each of the following actions clears this alarm: power cycle, short press of the S button, pressing any switch/button connected to any SW (SW, SW1, SW2, …) terminal.

NOTE: Surge protection is always active and cannot be disabled.
Additional description above in section Notification of detected overvoltage .

Supported load types

• Resistive (incandescent bulbs, heating devices)

• Capacitor (capacitor batteries, electronic equipment, motor start capacitors)

• Inductive with RC snubber (LED drivers, transformers, fans, refrigerators, air conditioners)

User interface

S button and operating modes

1. Normal mode

2. Setting in progress mode

3. Setting mode (S button)

   • The setup mode is required to start the desired procedure, for example: add (add), remove (remove), reset to factory settings, etc. Its operating time is limited. After completing the setup mode procedure, the device automatically switches to normal mode.

   • Entering setup mode:

     • Press and hold the S button on the device until the LED turns blue.

     • An additional quick press of the S button means changing the menu in an infinite loop

     • The menu LED status time is 10 s before returning to normal status.

S button functions

• Manually Adding a Device to a Z-Wave Network

• Manually Removing a Device from a Z-Wave Network

• Factory reset the device